PowerToolCliff

Wear point

The claw and tine

This part on the catalog strip

Across the whole catalog a tooth is sharp when any listing names that part. The lit tooth is this page.

6 of 6 teeth sharp

  • Battery: named
  • Bit tip: named
  • Blade edge: named, replacement stated
  • Chuck and drive: named
  • Nozzle and filter: named
  • Claw and tine: named

Listings naming it 3

Listings silent on it 39

What goes first

On a weeder the working end is a set of claws or a shaped head. This page counts claws and heads; the bladed crack weeder is counted under the blade edge.

What the listings say

Three listings name claws or a head, and each of them names what it is made of. The count of weeder listings printing a length or any other figure is none.

ASTM A240 is a specification for stainless steel plate, sheet and strip, and ISO 15510 lists the chemical compositions of stainless steels. ASTM B26 covers aluminum-alloy sand castings.

A listing that names a material has named a material. It has not named a grade or a specification, and this site does not supply one.

Silence is silenceA weeder listing that names only its handle has said nothing about the part that meets the ground, and nothing about that part is assumed here.

Tool types that name this part

Wear Points · Wear Point Check